Scope of application
This regulation is applicable to the packaging of rolled composite plate products.
Operation process
- Rolled stainless steel clad steel plate
- Inspectors shall paste special product labels on the qualified products in final inspection (the unqualified products in final inspection will be dealt with separately) and special product labels.
Name&Specification |
| width(mm) |
---|---|---|
big label | 210 | 130 |
little label | 210 | 13 |
remarks | type face: Arial |
- The large label shall be attached to the corner plate of the cladding, 50-80mm away from the edges of the two plates, and the small label shall be attached to the section of the long side of the corner of the cladding, 50-80mm away from the end of the composite plate (transparent tape is allowed to be used to reinforce the label), as shown in Figure.
- Schematic diagram of paste position
Paste protective film on the cladding surface according to the product size, as shown in Figure.- Schematic diagram of sticking protective film
![]() | ![]() |